Hi All

I am trying to install my vs.net2003, and keep getting a error message. The
message is

"Setup is unable to run a program needed to proceed with the installation.
Restart your system and try again. Error 105."

This is during Step 1, I skip the bit on installing ISS, etc, then it pops
that error. I have admin prev. on my Laptop (Dell Inspiron 5150) and have
rebooted several times. Did a search for Error 105 and couldn't find anything
suitable. Any ideas?
--

Thanks

Shawn

Hi Shawn,

Could you please inform me if you've found the solution to your problem
'cause I'm stuck w/ the exact same problem. I would really appreciate it

Martin

"Shawn" wrote:

Yes, one of the guys at work stepped me through it, you had to install each
bit via it's own setup.exe. Can't recall the exact steps, and we did it by
the seat of or pants with a lot of "I think it was that one", so I can't give
you the steps I followed, prob. should have wrote them down, sorry. But the
above info might help ya a bit.

"Martin" wrote:

There's a moreinfo.htm file in the installation that explains how you can install individual components. I followed the steps in that to get around the 105 problem

From http://www.developmentnow.com/g/3_20...vs-net2003.htm

Posted via DevelopmentNow.com Groups
http://www.developmentnow.com